Dmx Operation; Dmx-Protocol - EuroLite LED PSU-8A Bedienungsanleitung

Set the Master device to Automatic or Sound Control Mode and set each Slave device to the same DMX
address or DMX mode.

DMX operation

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED light tube will respond to the controller.
Every DMX channel has a different occupation with different features.
Attention:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX input, the display will flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Addressing
Press the Mode button until the display shows A.001.
Set the desired address (between A.001 und A.512) via the Up or Down buttons.
Controlling:
After having addressed the LED PSU-8A Artnet/DMX, you may now start operating it via your lighting
controller.
The LEDs of the LED Tube are separated into pixels which can be individually controlled with Madrix.
Choosing a DMX Channel Mode (3 optional modes)
After having set the desired addresses and pressed ENTER, you can now choose a DMX Channel Mode.
Via the Up or Down buttons, you can choose between the DMX modes "CH05, CH07, CH26".
Please see the following DMX protocol graphics for the respective channel values.

DMX-Protocol

5-Channel mode:
Channel Value
1 000-255
2 000-255
3 000-255
4
000-255
000-000
001-005
5
006-010
011-255
Function
Red (0 - 100 %)
Green (0 - 100 %)
Blue (0 - 100 %)
Dimmer (0 - 100 %)
No function
Sound control (24 programs as continuous loop)
No function
Strobe, with increasing speed (flash frequency 0.1-20HZ)
26/32 00090356, Version 1.0