Operation; Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL RT-VE 550 Originalbetriebsanleitung

Anleitung_RT_VE_550_SPK1:_
Pull the dust bag (6) over the bottom opening in
the plastic housing (13) so that it completely
surrounds the opening and secure it using the
quick-release device (5) (Fig. 12).
Move a hose fastening (A) over the extractor
hose (11). Plug the extractor hose (11) onto the
extractor connection of the equipment as far as
the stop and secure the hose to the connection
using the hose clip (A) (Figure 13).
If equipment with an extractor connection
diameter of 100 mm is to be connected to the
extraction system, slip a hose fastener (A) over
the extractor hose (11). Now plug the connection
adapter (17) into the extractor hose (11) as far as
the stop and secure it by tightening the hose
fastener (A) (Fig. 14-15). Plug the connection
adapter (17) onto the extractor connection of the
equipment you want to use.

8. Operation

8.1 Switching on (Fig. 1,17)
Check whether the extractor hose (11) is tightly
connected to the vacuum extraction system and
to the extractor adaptor of the wood processing
machine.
Check whether the debris bags (2/6) are
securely fastened.
Switch on the vacuum extraction system by
pressing the green button "I".
Switch on the wood processing machine.
8.2 Switching off (Fig. 17)
Switch off the wood processing machine.
Switch off the vacuum extraction system by
pressing the red button "0" or by pressing the
emergency stop button (19).
8.3 Emptying the sawdust bag
Inspect and empty the sawdust bag (6) regularly!
Important: Remove the power plug!
Hold the filled sawdust bag in place with one
hand.
Open the quick clamp device (5).
Remove the bag and dispose of the contents in
an environmentally-friendly fashion.
Put the bag back into the holder and secure with
the quick clamp device (5).
27.11.2009 8:04 Uhr Seite 15
8.4 Transportation (Fig. 6)
The vacuum extraction system has a standard
chassis (8).
For transportation, gently lift the vacuum
extraction system by the transportation handle
(4) and move it to the desired location.
9. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
9.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
9.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
9.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

10. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
15