Safety Regulations; Before Starting The Equipment; Technical Data - EINHELL RT-VE 550 Originalbetriebsanleitung

Anleitung_RT_VE_550_SPK1:_
GB
Hazard due to wood dust: The inhalation of
wood dust is a health hazard! Always wear a
protective dust mask when emptying the debris
bag. When disposing of sawdust waste, make
sure you do so in an environmentally-friendly
fashion!
Fire hazard: Never use the machine to extract
hot objects!
Damage to hearing if ear-muffs are not used as
necessary.
Harmful emissions of wood dust when used in
closed rooms.

4. Safety regulations

The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.

5. Technical data

Motor
Motor speed n
0
Power P
Protection type
Max. vacuum
Max. extraction volumes
Extractor socket
Sawdust bag volumes
Weight
Noise
Sound and vibration values were measured in
accordance with EN 60335-2-69.
L sound pressure level
pA
L sound power level
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
14
27.11.2009 8:04 Uhr Seite 14
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.

6. Before starting the equipment

Unpack the vacuum extraction system and
check it for damage which may have occurred in
transit.
The machine has to be set up where it can stand
securely. All covers and safety devices have to
be properly fitted before the machine is switched
on.
Before you actuate the On/Off switch, make sure
that the debris bags are securely fastened!
Check that the voltage on the rating plate is the
same as your supply voltage before you connect
the machine to the power supply.
7. Assembly (Fig. 1, 3-15)
Important. Pull out the power plug before
220-240 V ~ 50Hz
carrying out any maintenance, resetting or
assembly work on the vacuum extraction
2900 rpm
system!
550 W
IP 20
Undo the two nuts (E) on both sides of the plastic
1600 Pa
housing (13) (Fig. 3).
Guide the side plates (12) over the screws on the
1150 m 3 /h
plastic housing (13) and secure them with the
100 mm
nuts (E) (Fig. 4-5).
65 l
Place the strengthening plate (9) between the
22,5 kg
side plates (12) and secure it with the screws (B)
and nuts (C) (Fig. 6).
Secure the chassis (8) to the side plates (12)
using the screws (D) and nuts (C) (Fig. 7).
Now thread the quick-release device (3) through
the sewn-in guide in the dust bag (2) (Fig. 8-9).
Place the dust bag hook (1) into the hole for the
dust bag hook (14) on the plastic housing (13)
and attach the dust bag (2) to the dust bag hook
75,5 dB(A)
(1) (Fig. 10).
95,5 dB(A)
Snap the dust bag (2) over the top opening in the
plastic housing (13) so that it completely
surrounds the opening and secure it using the
quick-release device (3) (Fig. 11).