Welding A Tube Fi Lm - Silvercrest SFS 110 A1 Bedienungsanleitung

Welding a tube fi lm
GB
8
NOTES ON THE FILM
► The fi lm width may not exceed 28 cm. Otherwise it cannot be welded
correctly.
► Use only nylon-PE fi lms with a structure (points or grooves) on one side and
that have a structure (points or grooves) on one side and a thickness of
approximately 0.17 - 0.29 mm (170 - 290 μ).
Otherwise the weld seam will not be tight and the appliance may be da-
maged. You can recognise fi lms of this type from the information on the
packaging. The quality of the weld seam will vary depending on the type
and thickness of the fi lm.
► The supplied fi lm is suitable for temperatures between -20°C and +100°C.
1) Cut the desired length for your bag from the tube fi lm using a pair of scissors.
Cut as straight as possible.
2) Open the appliance lid 1 by pressing the lid release 8 and opening the
lid 1 upwards.
3) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring 5. The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7. If the bag lies over one or both of the two limiters 7, then the
bag cannot be correctly welded.
SFS 110 A1