Oil Feeding And Mixing; Start - maruyama MS0735W(CE) Bedienungsanleitung

Oil feeding and mixing

Oil feeding
・Make sure you use blended fuel.
Gasoline : exclusive oil
25 : 1
Use exclusive oil for two-cycle engine engines.
Neither overfill nor
spill the fuel on to
the engine.
filler opening
DANGER
There is a possibility of fuel igniting. Make sure
you observe the following items.
・When feeding fuel, stop the engine and
ensure no source of fire such as cigarette is
close to the area.
・Don't spill fuel. If fuel is spilled, wipe it all off
at once and start the engine after it is dry.
・Don't feed fuel above the standard line.
There is the possibility of leakage.
・When a fuel leakage is found, use the
engine after repair are done.
・After feeding fuel, make sure you close the
fuel tank cap.
English
CAUTION
・If operating the machine with gasoline
alone, the engine will seize.
Make sure to mix exclusive two-cycle engine
oil in the specifled quantity.
・The mixing ratio shall be the designated
ratio for exclusive two-cycle engine oil.
・Use lead-free gasoline for automobiles for
fuel.
Mixing chemicals
・Read the instructions for the chemical to be
used carefully and follow the mixing method
and cautions for use.
Close securely
chemical tank lid
・After confirming the proper placement of the
chemical cover, close the cover securely.
Otherwise, chemicals will spill and you might
be covered with them when you carry the
machine on your back.
11

Start

Start of engine
CAUTION
・When starting the engine, make sure to put
water or chemicals into the chemical tank.
Without water or chemicals in the tank, the
pump will break down. Never run the pump dry.
・It is confirmed that the ball cock has closed
before it starts.
1
Perform priming.Push priming pump installed
in front of the carburetor several times slowly,
and confirm that fuel fills the priming pump
and returns to the tank through the clear
return line.
2
Fully close the choke. (In hot weather or
when engine is hot, the choke should be
partly open or fully open.)
Close
3
Move throttle lever to medium-and low-
speed position.
H
L
Throttle lever
4
Set handle of pressure control valve at
"STARTING" position.
STARTING
12
English