Chauvin Arnoux C.A 6545 Bedienungsanleitung Seite 39

2.2.1 Digital display.
The main digital display indicates the values for insulation measurement: resistance, DAR PI, DD or
capacity).
The small digital display indicates the voltage measured or applied by the instrument.
During the insulation measurement, the elapsed time or
After the recording of a group of data (C.A 6547), the small display also indicates the date and time in
MR (Memory recall) mode. It is also used to indicate the memory address using the OBJ number. TEST
(see § 2.2.3 Symbols).
2.2.2 Bargraph
The bargraph is active during insulation measurement (0.1 MΩ to 1 TΩ). It is also used, to indicate the
battery charge, and the memory space, a segment representing approximately 50 groups of storable
values.
2.2.3 Symbols
MEM/MR indicates the memorisation (MEM) or memory reading (MR) operations (C.A 6547)
OBJ: TEST Memory address (C.A 6547): the number is displayed above, on the small digital display.
COM Flashes on the screen when the data is transmitted to the serial interface (C.A 6547) or is
displayed constantly if there is a problem during transmission.
DAR/PI/DD indicates the mode chosen before the insulation measurement or the results of these
measurements.
Voltage generated dangerous, U > 120 V
!
External voltage present, symbol activated following press on the START push button, if U
> 25 V ±3 V or > 35 V
AC
Activation of the "Programmed-time test" mode or, on the SET-UP position of the switch,
clock adjustment (C.A 6547). Flashes with each sample recording.
Indicates that the secondary function of a key will be used
2nd
Flashes if the battery is low and must be recharged (see § 8. Maintenance).
The voltage is displayed on the small digital display for 2 seconds when the device is
switched on. The main display indicates «bat «. This test is performed internally on a load
corresponding to the functional measurement.
The audio warning (buzzer) is activated
Indicates that the automatic stop function is deactivated
SMOOTH Smoothing of insulation measurement display
REMOTE Remote control via interface (C.A 6547). In this mode, all the keys and the rotary switch are
inactive, except when stopping the instrument.
FUSE -G- Flashes if the fuse of input «G» is defective.
voltage is displayed.
output
.
DC
DC
39