C) Operation As Conventional Av Transmitter (Without Computer) - Conrad Grand Ultimate Wireless Bedienungsanleitung

c) Operation as conventional AV transmitter (without computer)

Naturally, you can use the product without computer also.
The VGA-TV converter is equipped with a video input ("VIDEO IN", 5) and an audio input ("AUDIO IN", 8). The applied
signals are transmitted wireless to the AV receiver.
Proceed as follows:
• Switch off all devices and disconnect them from the mains power (pull out the power plug).
• Select the same channel on the TV converter and on the AV receiver. This is possible via the DIP switch (see
fold-out page, position 4 and 15).

Only one of the small switches should be switched to the "ON" position, namely on the TV converter
and the AV receiver respectively, always the switch with the same number (e.g. move switch "1"
downward on "ON", all other switches upward).
• Connect the AV receiver with the video input of your TV set for example. Use, if necessary, an AV-SCART adapter
if the TV set is not equipped with 3 cinch sockets for the AV input (video, audio left, audio right).
• Connect the VGA-TV converter to your AV device, for example, to a DVD player. To that effect, use the video
input "VIDEO-IN" (5) on the VGA-TV converter and the audio input "AUDIO-IN" (8).
• Connect the power sockets of the VGA-TV converter and AV receiver respectively to one of the two plug-in mains
units included in the delivery (both units are of the same type!). Plug the mains units into a mains socket (230V~/
50Hz).
• Connect all other devices again with the mains voltage and switch them on (to switch on the VGA-TV converter,
briefly press the "POWER" key located on the top side.
29