Herunterladen Diese Seite drucken

Powerfix Multi-Purpose Ladder Bedienungsanleitung Seite 2

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 16
Safety instructions / Assembly / Before use
using the ladder as a lean-to ladder (see Figure B).
J
D o not use the top two rungs of the ladder as a platform if you are using
the ladder as a stepladder (see Figure B).
J
A ttched to the ladder frame
safe use of the ladder. Follow the advices on the pictograms to avoid
accidents:
Before using the ladder, please read the use instructions
very carefully.
The extension of the ladder must be at least 1 meter above the
highest point beyond the exit location.
Maximum intended.
Make sure that the ladder is in perfect condition and without
any defects which could harm you.
Make sure that the ladder is completely unfolded before using
the ladder.
Check the ladder feet.
Maximum number of the users each ladder.
Please pay attention to the correct position of the ladder
angle. The ladder has always to be placed between an angle
of 65º and 75º.
Secure top / bottom of the ladder.
Keep the ladder joints on the inside oiled and free of dust
at all times.
Do not use the ladder without the base bars.
Do not stand on the top three rungs of a leaning ladder.
Set the ladder always on a level surface.
Warning! Do not insert a finger into the hole on the side
of the ladder frame.
Do not stand on the top two rungs of a standing ladder
without a platform and hand / kneerail.
Never climb up the ladder sideways and never climb from
ladder to ladder.
4
GB/CY
71609_pow_Alu-Teleskopleiter_Content_LB7.indd 4
you will find labels with pictograms for a
1
Do not use the ladder as a bridge.
Keep your body centered on the ladder avoiding leaning
too far sideways.
Make sure that the ground is dry, clean and free from any
pollution.
Never use this ladder in order to perform work on electrical
devices or construction parts which are under electrical tension.
The ladder may only be used by one person at a time.
Do not stand on the top rung.
Face ladder when ascending or descending ladder.
Make sure that the upper part of the ladder is always
correctly placed.
Set the ladder always on a firm, immovable ground.
assembly (figure a)
Q
j
S crew the two base bars
on to the ladder frame
7
supplied screws
and the washers
10
Before use
Q
j
A void damage when transporting ladders on roof racks or in a lorry.
Make sure that the ladder is appropriately fastened in place
j
B efore using the ladder, visually inspect it. Check that all parts are
undamaged and in good working order. You may have to grease the
blocking devices
if they are stiff.
4
j
R emove all contamination on the ladder, such as wet paint, dirt, oil
or snow.
j
L ock all doors and windows (but not emergency exits) in the area around
the ladder where you are going to work.
using the four
1
.
11
15.11.10 11:51

Werbung

loading