Reely SKY Typhoon Bedienungsanleitung Seite 43

A rotor blade setting scale (1) aids in setting the rotor blades
(4) to 0° in the middle position. The pitch lever on the
transmitter and the servo arms are still in the middle
position.
Put the helicopter on a level area to do this. The paddle
rod is also adjusted to level with a small spirit level (2). To
correct the setting level, change the length of the rods (5)
from the blade holder to the mixing lever of the helicopter.
Finally, using the two paddle gauges (1+2), you check
whether the two paddles have the same angle to one
another.
These must also be in a horizontal position as related to
the linkage rocker (3).
After loosening the grub screws (4), you can make the
necessary fine adjustments.
Figure 7
Figure 8
43