Reely SKY Typhoon Bedienungsanleitung Seite 40

Activate programming mode:
• Switch on the transmitter, move the gas/pitch lever to the "full acceleration" position.
• Now connect the rechargeable battery with the speed controller.
• You hear the signal "di" and 2 seconds later "di--di".
• Wait another 5 seconds and the programming mode is activated.
• Now you'll hear 8 different sounds series (see the table below, column 1). If you wish to change the desired menu
item (table below, column 2), move the gas / pitch lever to the "motor off" position immediately after the corresponding
sound series is emitted. You will hear a "di" signal.
Then you will enter the respective sub-menu (see the table below, column 3). If you wish to change a parameter, you
need to move the gas / pitch lever to the full acceleration position within one second of the respective sound being
emitted. You will then hear a "di" signal.
If you do not wish to change a parameter, you need to move the gas / pitch lever back to the "motor off" position
within 2 seconds of the last recognition sound being emitted. The controller then saves the selected settings.
If you wish to change additional parameters, repeat the process described above.
Move the (gas/pitch
lever to "full
acceleration" setting).
"di"
"di---di"
"di---di---di"
"di---di---di---di"
"di------"
"di------di---"
"di------di---di---"
"di------di------"
40
Menu item (select by moving the
gas/pitch lever to "motor off" position)
Electronic brake
Rechargeable battery type
Voltage shut-off at low voltage
Voltage cutout value for low-voltage
protection when using LiPo
rechargeable batteries (NiMH or
NiCd rechargeable batteries)
Set the start mode for the motor (time
for the motor to start up)
Type of motor used
Suppress recognition sound
Exit the settings menu
Sub-menu item: Select by moving the gas/pitch lever to "full
acceleration" position)
"di" = Off
"di—di" = On
"di—di—di" = not assigned
"di" = LiPo rechargeable battery
"di—di" = NiMH/NiCd rechargeable battery
"di—di—di" = not assigned
"di" = shutdown after 10 seconds
"di—di" = immediate shutdown
"di—di—di" = not assigned
"di" = Shutdown at 2.6 V (60% for NiMH/NiCd
rechargeable batteries)
"di—di" = Shutdown at 2.8 V (65% for NiMH/NiCd
rechargeable batteries)
"di—di—di" = Shutdown at 3.0 V (70% for NiMH/NiCd
rechargeable batteries)
"di" = start after 0.5 seconds
"di—di" = start after 1 second
"di—di—di" = start after 2 seconds
"di" = motor with 2 poles
"di—di" = motor with 6 poles
"di—di—di" = other