Getting Started; Inserting / Changing The Batteries; Using The Multifunction Detector - Powerfix Z29948 Bedienungsanleitung

Safety Instructions / Getting started
area with plenty of clean water and consult a doctor
immediately.
J
Remove light dirt from the battery and product con-
tacts with a dry, non-fluffing cloth before inserting the
batteries.
J
Remove the batteries from the product if it is not in use
for any length of time.
J
Make sure that the polarity is correct when you insert
the batteries. This is indicated in the battery compart-
ment. The batteries can otherwise explode.
J
Insert the batteries with care. The product can other-
wise be damaged.
J
Please do not dispose of used batteries in your house-
hold waste but take them to a designated collection
depot for special waste.

Getting started

Q 

Inserting / changing the batteries

Q 
j
note: First remove the protective foil from the device.
j
Open the battery compartment
appliance.
j
Remove the used batteries if need be.
j
Insert two new 1.5 V
tery compartment
note: Ensure correct polarity. This is indicated in the
battery compartment
j
Close the battery compartment

Using the Multifunction Detector

Q 
Tip! Test the device before initial use on a metal pipe
or power line whose position you know exactly.
j
Slide the function switch
locate metal pipes etc.
j
Slide the function switch
locate power lines etc.
j
Hold the measuring head
point of the wall.
j
Press and hold down the PUSH key
j
Move the device slowly over the wall surface.
note: Ensure direct contact between the measuring
head
10 GB/IE
5
and the wall.
1
on the back of the
5
batteries (AAA) into the bat-
.
.
5
again.
5
to "METAL" in order to
3
to "VOLTAGE" in order to
3
directly on the desired
1
.
4