Changing Spraying Material; Breaks In Work; Finishing Work And Cleaning The Unit - WAGNER FineCoat Spray Pack 9950 PP Betriebsanleitung

Wrong
• Excessive paint mist formation
• Uneven surface finish
Spraying technique when using textured and effect
paints:
When spraying with a flat fan, the distance to the object
should be between 3 and 20 cm.
3-20 cm
Spraying technique when using color-effect or multi-
color paints:
When spraying with a flat fan, the distance to the object
should be between 20 and 30 cm
Note: When selecting the round fan, the distance may
be increased depending on the object.
20-30 cm
GB

Changing spraying material

1. Switch off main switch.
2. Disconnect connection hose (blue).
3. Pull safety/pressure-relief valve until pressure has
been completely released (pressure gauge indicates
0 bar).
4. Open pressure-tank lid.
Caution! Do not open cover until pressu-
re has been released (pressure gauge in-
dicated 0 bar)!
5. Cleaning see page 25, point 6 and 7.
6. Pour in paint and start-up again as per page 21.

Breaks in work

1. Switch off main switch.
2. Release trigger.
3. Turn material adjusting knob (fig. 17) on gun clock-
wise as far as possible. The gun is now secured
(trigger cannot be actuated).

Finishing work and cleaning the unit

1. Switch off main switch.
2. Disconnect connection hose (blue).
3. Pull safety/pressure-relief valve until pressure has
been completely released (pressure gauge indicates
0 bar).
4. Open pressure-tank lid.
Caution! Do not open cover until pressure
has been released (pressure gauge
indicated 0 bar)!
5. Press trigger on gun until material no
longer exits at nozzle.
Caution! Never spray into a container
with only a small opening (bunghole)!
See safety regulations.
24