Maintenance; Scheduled Maintenance Table - Nilfisk SCRUBTEC 344 Bedienungshandbuch

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
This Manual describes only the simplest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery Charging
Squeegee Cleaning
Brush/pad cleaning
Recovery tank, debris tray, and vacuum grid with float cleaning,
and cover gasket check
Detergent System cleaning and washing (optional)
Squeegee blade check
Solution Filter Cleaning
Battery (WET) fluid level check
Squeegee blade replacement
Drive and brush motor vent check and cleaning
Brush motor carbon brush check or replacement
Drive system motor carbon brush check or replacement (only for
Drive versions)
(1) This maintenance procedure must be performed by an authorised Nilfisk Service Center.
18
INSTRUCTIONS FOR USE
SC401, SCRUBTEC 344 - 9100002291
Daily, after using
Weekly
the machine
Every six
Yearly
months
(1)
(1)
(1)
09/2017