Maintenance - Makita 3612C Bedienungsanleitung

Vacuum head set (Accessory)
For tool without lock plate
Fig.23
Use the vacuum head for dust extraction. Install the
vacuum head on the tool base using the two screws.
Fig.24
For tool with lock plate
Fig.25
Use the vacuum head for dust extraction. To Install the
vacuum head, raise the lock lever on it. Place the
vacuum head on the tool base so that its top will be
caught in the hook on the tool base. Insert the supports
on the vacuum head into the hooks on the front of the tool
base.
Push down the lock lever onto the tool base.
Fig.26
Then connect a vacuum cleaner to the vacuum head.
Fig.27
To remove the vacuum head, raise the lock lever. Pull the
vacuum head out of the tool base while holding the
supports between thumb and finger.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
Fig.28
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
Fig.29
NOTE:
When replacing carbon brush located on the same
•
side as the knob, remove the knob first before
unscrewing the brush holder cap.
CAUTION:
Be sure to re-install the knob after inserting new
•
carbon brush.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide
•
Trimmer guide
•
Guide holder
•
Templet guides
•
Templet guide adapter
•
Lock nut
•
Collet cone 12 mm, 1/2"
•
Collet sleeve 6 mm, 8 mm, 10 mm
•
Collet sleeve 3/8", 1/4"
•
Wrench 8
•
Wrench 24
•
Vacuum head set
•
Router bits
Straight bit
Fig.30
D A
6
20
1/4"
12
12
1/2"
12
10
1/2"
8 8
6
8
1/4"
6
6
1/4"
006452
"U"Grooving bit
Fig.31
D A
6 6
006453
"V"Grooving bit
Fig.32
D A
1/4" 20
006454
11
or attachments
Only use accessory or
mm
L 1 L 2
50 15
60 30
60 25
60 25
50 18
50 18
mm
L 1 L 2 R
50 18 3
mm
L 1 L 2
50 15 90
are