Maintenance - Makita 3612 Betriebsanleitung

Straight guide
When using the straight guide, be sure to install it on the
right side in the feed direction. (Fig. 8)
Install the straight guide on the guide holder with the
wing bolt (B). Insert the guide holder into the holes in the
tool base and tighten the wing bolt (A). To adjust the dis-
tance between the bit and the straight guide, loosen the
wing bolt (B) and turn the fine adjusting screw (1.5 mm
per turn). (Fig. 9)
Wider straight guide of desired dimensions may be using
the convenient holes in the guide to bolt on extra pieces
of wood. When using a large diameter bit, attach pieces
of wood to the straight guide which have a thickness of
more than 15 mm to prevent the bit from striking the
straight guide. (Fig. 10)
Trimmer guide
When using the trimmer guide, be sure to install it on the
right side in the feed direction. (Fig. 11)
Install the trimmer guide on the guide holder with the
wing bolt (B). Insert the guide holder into the holes in the
tool base and tighten the wing bolt (A). To adjust the dis-
tance between the bit and the trimmer guide, loosen the
wing bolt (B) and turn the fine adjusting screw (1.5 mm
per turn). When adjusting the guide roller up or down,
loosen the wing bolt (C). (Fig. 12)
Templet guide
For tool without lock plate
The templet guide provides a sleeve through which the
bit passes, allowing use of the router with templet pat-
terns. (Fig. 13)
To install the templet guide, loosen the screws on the tool
base, insert the templet guide and then tighten the
screws. (Fig. 14)
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide slid-
ing along the side of the templet. (Fig. 16)
For tool with lock plate
The templet guide provides a sleeve through which the
bit passes, allowing use of the router with templet pat-
terns. (Fig. 13)
To install the templet guide, pull the lock plate lever and
insert the templet guide. (Fig. 15)
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide slid-
ing along the side of the templet. (Fig. 16)
Dust extraction
For tool without lock plate
Use the vacuum head for dust extraction. Install the vac-
uum head on the tool base using the two screws. (Fig. 17
& 18)
Then connect a vacuum cleaner to the vacuum head.
(Fig. 21)
For tool with lock plate
Use the vacuum head for dust extraction. To install the
vacuum head, raise the lock lever on it. Place the vac-
uum head on the tool base so that its top will be caught in
the hook on the tool base. Insert the supports on the vac-
uum head into the hooks on the front of the tool base.
Push down the lock lever onto the tool base. (Fig. 19 &
20)
Then connect a vacuum cleaner to the vacuum head.
(Fig. 21)
To remove the vacuum head, raise the lock lever. Pull the
vacuum head out of the tool base while holding the sup-
ports between thumb and finger.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Replacement of carbon brushes (Fig. 22 & 23)
Replace carbon brushes when they are worn down to the
limit mark. Both identical carbon brushes should be
replaced at the same time.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
7