10. Replacing the batteries
When battery voltage is low, the LOW POWER status LED (10) lights up to inform
you that the batteries have to be replaced.
Proceed as follows to replace the batteries:
• Make sure the surveillance camera is switched off (see chapter "9.2 Switching
on/off the surveillance camera").
• Remove the cover from the battery compartment (7) pressing it downward.
• Remove the empty batteries.
• Insert 3 new AAA batteries/rechargeable batteries. Watch out for the right polarity.
• Push the cover back onto the battery compartment (7) to close it.
11. Maintenance and cleaning
Before cleaning the outside of the surveillance camera, switch it off.
To clean the outside of the camera, a dry, soft and clean cloth is sufficient.
Clean the lens very carefully, you may otherwise scratch it.
Apart from replacing the batteries (see chapter "10. Replacing the batteries") no part
of this device requires servicing.
28