• Attach the mounting base to the designated installation place using the doubled-
sided tape at the bottom.
• Place the surveillance camera on the mounting base as shown in fig. A (see chap-
ter "7. Display and control elements").
• Press the LASER button (2) to activate the LASER (5) on the front side. It helps
you to adjust the camera position.
• Set the position of the surveillance camera.
• Use the locking screw (4) to fasten the surveillance camera on the mounting base.
9. Operation
9.1 Inserting the batteries/rechargeable batteries
• Remove the cover from the battery compartment (7) pressing it downward.
• Insert 3 new AAA batteries/rechargeable batteries. Watch out for the right polarity.
• Push the cover back onto the battery compartment (7).
Now you can switch on the surveillance camera.
9.2 Switching on/off the surveillance camera
To switch on the surveillance camera, hold down the POWER button (3) für 2 sec-
onds.
The WORK LED (9) will light up once and then go off again for 1 to 2 seconds. As
soon as the surveillance camera is operational, the WORK LED (9) is on perma-
nently.
25