Power Supply; Battery Installation / Replacement Of Batteries; Operation With Power Supply Unit; Setting Up And Mounting - Conrad Electronic 75 12 21 Bedienungsanleitung

A Camera lens
B Battery case
C Operating switch
D Operating panel
E Tripod mount
F Video cinch connection cable
G Plug-in power supply unit
H Tripod with mount material
The operating panel (D) has the following elements
1 Luminous display
signals the switched-on setting menu
2 Selection switch for image format and memory mode
3 "MENU" button for setting menu and exiting (EXIT)
4 Video output jack
The image signal is outputted on this socket and it also serves to connect
the video cinch connection cable (F).
5 Rewind button with setting function (-)
6 Operating voltage jack
Connection jack for low-voltage plug of the plug-in power unit (G).
7 Operating display
8 Fast forward button with setting function (+)
9 "PLAY" button for playback, pause and setting function
10 "REC" button for stop, record and setting function
11 Luminous display signals playback function
12 Luminous display signals record function
36
6.

Power supply

6.1

Battery installation / replacement of batteries

Proceed as follows to replace the batteries/rechargeable batteries:
1. Separate the plug-in power supply unit (G) from the
camera.
2. Open the battery compartment lid.
3. Slide it downwards in the direction of the arrow as
illustrated.
4. Insert four batteries (type AA) in the battery
compartment, paying attention to the polarity
markings. Observe of the polarity markings in the
battery compartment.
5. Close the battery case again.
The surveillance camera can also be operated with batteries or rechargeable
batteries for short periods. This enables operation independent of the power supply.
6.2

Operation with power supply unit

1. Connect the low-voltage plug of the power pack (G)
with the operating voltage socket of the camera (6).
2. Plug the power supply unit into a suitable mains
socket.
3. The camera is now ready for use.
7.

Setting up and mounting

Find a suitable place for mounting from which the object to be monitored can be observed. A
suitable place for mounting has the following features:
• as free from dust as possible
• little vibration
• good air circulation
• a mains socket in the vicinity (for long-term operation)
The camera and the power supply unit are not weatherproof. Set up the camera in a
dry environment (perhaps weatherproof enclosure or something similar).
37