Installation In The Radio Recess - Renkforce CD-7516 Bedienungsanleitung

Installation in the Radio Recess

• Remove the front control panel.
• Carefully remove the plastic frame in the front of the system, by bending it slightly to the outside and pulling it off
the unit.
1
1
2
• Remove the two CD drive securing screws (fig. 1, no. 1).
• Unlock the installation frame with the two unlocking keys (fig. 1, no. 2).
• Remove the installation frame off the back of the system (fig. 1, no. 3).
• Insert the frame into the stereo slot in the vehicle (fig. 2).
• Bend down a few of the clips on the installation frame until the frame is securely fastened in the recess.
• Once you have secured all the electrical contacts (see "Electric Connection") insert the device into the frame until
it securely locks into place (fig. 4).
• Replace the frame cover of the front control panel.

Keep the two unlocking keys somewhere safe. You will need them for a later removal of the device.
Protect your CD tuner against vibrations with the bolt at the back of the unit.
In most vehicles, such a safety fastening is provided for. If this is not the case in your car, fasten the CD tuner with
a hole-punched metal strip or similar.
2
3
182mm
3
53mm
4
45