Installation into the Radio Recess
•
Remove the front control panel.
•
Carefully remove the plastic frame in the front of the system, by bending it slightly to the outside and pulling it off
from the unit.
1
1
2
•
Remove the two security screws of the CD drive (fig. 1, no. 1).
•
Unlock the installation frame with the two unlocking keys (fig. 1, no. 2).
•
Remove the installation frame towards the back of the system (fig. 1, no. 3).
•
Insert the frame into the respective cut-out in the vehicle (fig. 2).
•
Bend down some clips in the installation frame until the frame is securely fastened in the recess.
•
When you have made all the electrical contacts (see "Electric Connection") insert the CD tuner into the frame until
it locks in (fig. 4).
•
Replace the frame cover of the front control panel.
Keep the two unlocking keys. You will need them for a later removal of the CD tuner.
Protect your CD tuner against vibrations with the bolt at the back of the unit.
In most vehicles, such a safety fastening is provided for. If this is not the case in your car, fasten the CD tuner with
the enclosed punched metal strip.
2
3
182mm
3
53mm
4
43