Renkforce CD-7516 Bedienungsanleitung Seite 59

TA button (6)
This button calls up the RDS OPTIONS/TRAFFIC ALERT menu. Selection is carried out by turning the VOLUME dial
(3) and confirmation with the MENU button (2).
• TA OFF = the traffic alert is switched off.
• TA SEEK = if the radio has lost the traffic information, it will seek a new station with Traffic Announcement coding.
• TA ALARM = when the radio cannot receive the TA code any more, there will be an alarm signal.
When a TA function is activated (TA SEEK or TA ALARM) only stations with traffic information identification can be
received. If a different audio source is being played (a CD for instance), the programme is set to mute during the traffic
announcement. When you are listening to a radio programme at a very low volume, the volume is automatically
increased to an easily audible level during the traffic announcement. When the traffic announcement is over, the
volume you were hearing before is restored.
PTY button (7)
This button calls up the SEARCH/PROGRAM TYPE menu. Selection is carried out by turning the VOLUME dial (3)
and confirmation with the MENU button (2).
• Select a programme type and briefly press the MENU button (2). The automatic search is started for a station
which has the preselected PTY code.
• If no station is found with the corresponding PTY identification, the device emits 3 warning sounds.
AS/PS button (12)
• If you press this button shortly, the stations stored on the station buttons 1-6 (4) are played for 5 seconds each.
To stop the auto-scan, press the button again.
• If you hold the button down, all the stations that can be received well are stored on the station buttons 1-6 (4).
• After this procedure, the stored stations are played for 5 seconds each, as described above.
(13) SCAN Key
• This button starts the auto-scan.
• If a station has been found, it is played for 5 seconds and then the auto-scan is continued.
• Press the button again to stop the auto-scan to listen to the currently played station.
59