Charging The Battery - Waeco PerfectCharge IU12 Bedienungsanleitung

Using the charger
Note
I
The positive terminal is not connected to the bodywork when it is
connected.
Connect the black negative terminal of the charger to the nega-
tive terminal of the battery (designation –) (fig. 6 B, page 4).
Note
I
The negative terminal is connected to the bodywork when it is con-
nected.
The charger is ready to charge the connected battery.
6.2

Charging the battery

The charger can charge non-maintenance-free and maintenance-
free lead acid batteries (wet, gel and fleece types) with a rated volt-
age of 12 V.
Warning – danger of explosions!
d
Do not use the device with batteries with other rated voltages.
Note
I
During the charging process you can interrupt the charging process
at any time.
To charge the batteries, proceed as follows:
Connect the charger (chapter "Connecting the charger" on
page 34).
Set the switch (fig. 7 3, page 5) to "I".
Caution – risk of damage
e
If the red LED (fig. 7 1, page 5) is lit, you have connected the
battery terminals with reverse polarity.
Switch off the charger and correct the connections.
The automatic charging process starts.
The blue charging display (fig. 7 2, page 5) displays the cur-
rent charging status of the battery.
36
IU6, IU8, IU12