Using The Battery Charger; Charging Batteries - Waeco mobitronic MBC-2000A/S Bedienungsanleitung

MBC-2000.book Seite 23 Mittwoch, 30. Juni 2004 5:19 17
battery charger
5
You can use the battery charger either to charge dead batteries or to jump-
start vehicles with dead batteries.
5.1
➤ Before charging, isolate the vehicle battery from the vehicle's electrical
➤ First unclamp the negative pole, then the positive pole.
The following data needs to be re-entered when you re-clamp the charged
battery.
You can find information on re-entering this data in your vehicle's user man-
ual.
Prepare the battery as follows for lead starter batteries:
➤ Unscrew the sealing caps of each battery cell as far as possible.
Downloaded from www.Manualslib.com

Using the battery charger

Charging batteries

system so that the system cannot be damaged.
Please note that when you unclamp the battery, all temporary
memories of the vehicle's electronic systems lose their saved
data.
Radio code
Vehicle clock
Timer
On-board computer
Seat positions, etc.
When situating the battery charger, make sure it is secure and
cannot tip over. Never subject the mains lines and connection
lines to the battery to physical strain, creasing or sharp edges.
Warning!
Make sure to avoid contact with the battery fluid!
manuals search engine
Using the battery charger
23