Charging A Battery - Waeco PerfectBattery BC400 Bedienungsanleitung

MBCC-400.book Seite 28 Montag, 18. Februar 2008 4:00 16
Using the compact charger
6.4
➤ Select the charging current by setting the charging switch (fig. 1 1,
➤ Connect the mains cable (fig. 2 1, page 3) to a 230 V socket.
✓ The battery charging process starts now.
✓ The "Charging" LED (fig. 1 9, page 3) glows.
When the battery is fully charged:
✓ The "Charging" LED (fig. 1 9, page 3) goes out.
✓ The "Full" LED (fig. 1 8, page 3) glows.
6.5
➤ After use, first disconnect the connection to the AC mains.
➤ Disconnect the black cable from the negative terminal of the battery.
➤ Disconnect the red cable from the positive terminal of the battery.
28
Downloaded from www.Manualslib.com

Charging a battery

page 3) to the required value.
Note
During the charging process you can
– Interrupt the charging process at any time or
– Change the charging current by setting the charging switch
(fig. 1 1, page 3) to the desired value.
Shutting down the compact charger
manuals search engine
PerfectBattery BC400