Charging The Battery - Waeco PerfectCharge IU6 Bedienungsanleitung

_IU6_IU8_IU12_BA_10s.book Seite 36 Mittwoch, 16. Januar 2008 2:06 14
Using the charger
I
Note
The positive terminal is not connected to the bodywork when it is
connected.
➤ Connect the black negative terminal of the charger to the nega-
tive terminal of the battery (designation –) (fig. 6 B, page 4).
I
Note
The negative terminal is connected to the bodywork when it is con-
nected.
✓ The charger is ready to charge the connected battery.
6.2

Charging the battery

The charger can charge non-maintenance-free and maintenance-
free lead acid batteries (wet, gel and fleece types) with a rated volt-
age of 12 V.
d
Warning – danger of explosions!
Do not use the device with batteries with other rated voltages.
I
Note
During the charging process you can interrupt the charging process
at any time.
To charge the batteries, proceed as follows:
➤ Connect the charger (chapter "Connecting the charger" on
page 34).
➤ Set the switch (fig. 7 3, page 5) to "I".
e
Caution – risk of damage
If the red LED (fig. 7 1, page 5) is lit, you have connected the
battery terminals with reverse polarity.
Switch off the charger and correct the connections.
✓ The automatic charging process starts.
✓ The blue charging display (fig. 7 2, page 5) displays the cur-
rent charging status of the battery.
36
IU6, IU8, IU12