Set The Date And Time - Welch Allyn Spot Vital Signs Bedienungsanleitung

English

Set the date and time

After recharging a dead battery or after disconnecting the battery for a few minutes, you
must program the date and time screen.
You can change several device operating parameters in the Internal Configuration Mode.
When changed, these settings become the default power-up settings. You will also see
non-changeable device configurations for technical service purposes.
To enter the Internal Configuration Mode:
1. Turn the Spot Vital Signs off (
2. Press and hold the Blood Pressure Start/Stop (
device enters the Internal Configuration Mode and displays the software version.
If the device displays E38, press the Next Patient/Clear/Cancel (
cancel the error.
3. Press the Mode (
you see the date option displayed on the screen.
4. Use the Next Patient/Clear/Cancel (
buttons to change the default setting.
).
) button to cycle through the Internal Configuration menu until
) or Blood Pressure Start/Stop (
) and Power ( ) buttons. The
) button to
1
)