Continuity Test - VOLTCRAFT VC-540 Bedienungsanleitung

f) Continuity test
make sure that all circuit parts, circuits and components and other objects of
measurement are disconnected from the voltage and discharged.
- Turn the DMM on and select measuring range
Press "MODE" button to switch measurement
functions. The symbol for continuity test now
appears in the display. Pressing this button again
takes you to the next measuring function, etc.
- Plug the red measuring line into the v measuring
jack (9) and the black measuring line into the COM
measuring jack (8).
- An approximate value of less than 50 Ohm is identi-
fied as continuity; in this case a beep sounds. The
measuring range is up to 500 Ohm.
- If "OL." (overload) appears on the display, you have
exceeded the measuring range or the measuring
circuit is interrupted.
- Remove the measuring lines from the object to be
measured after completion of the measurement and
switch off the DMM.
.
55