VOLTCRAFT VC-540 Bedienungsanleitung Seite 47

P MAX Display of the AC maximum value within 1 millisecond (only for current and
voltage)
P MIN Display of the AC minimum value within 1 millisecond (only for current and
voltage)
REL Call relative value measurement and set reference value or zero reconciliation
for the direct current measuring range (only mA- and A-DC)
Δ Delta symbol of relative value measurement (= reference value display)
OL Overflow display, the measuring area was exceeded
Battery change display. Replace the batteries as soon as possible to avoid
measuring errors!
Symbol for the battery data used
Symbol for the diode test
Symbol for the acoustic continuity tester
AC Symbol for alternating current
DC Symbol for direct current
v, mv volt (unit of electric voltage), Milli-volt (exp.–3)
A, mA Ampere (unit of electric current), Milli-Ampere (exp.–3)
Hz Hertz (unit of electrical frequency)
°C, °F degrees Celsius/degrees Fahrenheit (unit for the temperature)
Ω, kΩ, MΩ Ohm (unit of electrical resistance), Kilo-Ohm (exp.3), Mega-Ohm (exp.6)
nF Nanofarad (unit of electric capacity, exp.–9)
µF Microfarad (exp.–6)
mF Millifarad (exp.-3)
Symbol for the capacity measuring range
Bargraf bar display (not for Hz, CAP and °C°F)
Polarity marking (plus pole) for direct current measurement. The symbol shows
the current flow duration to measure in the correct polarity.
47