Synchronisation Of The Playback Speed - Renkforce 1377584 Bedienungsanleitung

k) Synchronisation of the Playback Speed
To mix or cross-fade two signal sources "cleanly", the beats have to be synchronised in many cases.
This can be achieved in three ways:
• Using the PITCH slider (10). It allows you to permanently modify the speed. This function is used when
two tracks have two completely different tempos.
• Using buttons PITCH +/- (11). This allows you to change the speed temporarily. This function is used
when two tracks have the same beat but the starting point has to be synchronised.
• Using the JOG/SHUTTLE wheel (21). By turning the wheel, you can change the speed temporarily. This
function can also be used when two tracks have the same beat but the starting point has to be synchro-
nised.
PITCH slider
• Push and hold the PITCH button (12) at the device or at the remote control until the button at the device
lights up. The slider PITCH (10) can now be used.
• Put the slider PITCH (10) into the middle position 0. Set the desired control range of the PITCH slider by
briefly pushing the PITCH button (12). The selected control area is displayed briefly.
• Modify playback speed by moving the PITCH slide control (10) up or down. The set value for the speed
change is displayed. Put the slider in centre position for original playback speed.
• The function can be switched off again by pushing the PITCH button (12) until it is no longer lit.
PITCH +/- buttons
• Hold down the PITCH +/- (11) buttons during playback to change the speed.
The PITCH - button reduces speed.
The PITCH + button increases speed.
• The longer the PITCH BEND button is held down, the bigger the corresponding playback speed change.
The value for the speed change is not displayed.
• When the button is released, the music is played back at original speed or at the speed specified by the
PITCH slide control (10).
JOG/SHUTTLE wheel
• Use the PITCH BEND / SEARCH / SCRATCH button (22) to select the function PITCH BEND for the JOG/
SHUTTLE wheel (21). The function is active when the button is not lit.
• By turning the JOG/SHUTTLE wheel (21), you can change the speed temporarily. The speed change
depends on how quickly the JOG/SHUTTLE wheel is turned. The value for the speed change is not dis-
played.
42