Integrating The "Fs20 S20-3" Radio Remote Control Into The Address System; A) Adjusting The House Code; Setting The Address - Conrad FS20 S20-3 Bedienungsanleitung

11. Integrating the "FS20 S20-3" Radio Remote Control
into the Address System
The house code, an address group and a sub-address are used for coding the remote control.
The remote control can be programmed as a local or global master using special address
group assignments.

Only the buttons „
code, the 2-digit address groups and the 2-digit sub-address (see diagram in
Chapter 8 "Controls")
With this form of addressing there are 225 individual address, 15 function groups, 15 local
master addresses and 1 global master address available within each house code.

a) Adjusting the House Code

After the batteries are inserted the remote control selects a random house code.
This house code can be adjusted as follows if required:
1
• Hold down the "
light LED flashes once a second.
• Now use the „ 1
system. This code must be the same for all remote control transmitters used in the FS20
radio switching system (note the number and store it safely).
Example: 23141342 (1= Button "
• After the eighth digit is entered the programming mode is automatically exited. The control
light LED goes off.
b) Setting the Address
A channel's address is made up of the 2-digit address group and the 2-digit sub-address (e.g.
1131, address group 11, sub-address 31).

The factory setting for channels 1 to 8 is address group "11". Channel 9 is set
as a function group and channel 10 as a local master
34
1 2
", „
3
" and " " buttons on the remote control for 5 seconds until the control-
", „ 2 ", „ 3 " and „
1
3 4
", „ " and „ " are used to enter the 8-digit house
4 " buttons to enter the 8-digit house code for your
2
", 2= Button " ", 3= Button "
3 4
", 4= Button " ")