Addressing With Double Channel Number; Restoring Factory Settings - Conrad FS20 S20-3 Bedienungsanleitung

Local master (xx44)
If the sub-address is set to 44, then this channel functions as a local master within the set
address group. All receivers which are programmed with this local master address will be
controlled commensurately.

Possible settings: 1144, 1244, 1344, 1444, 2144, 2244, 2344, 2444, 3144,
3244, 3344, 3444, 4144, 4244, 4344
Global master address (4444)
If the address group and sub-address of a channel is set to 44, then this channel functions
as a global master. All receivers which are programmed with this global master address will
be controlled commensurately.

4444 is the only possible global master address.

3. Addressing with Double Channel Number

Please proceed as follows to change the address group and sub-address of an individual
button:
- Press and hold the button to be programmed.
Press the button next to it as well; now hold down both buttons together for at least 5
seconds!
The control light LED flashes once a second when programming mode is activated.
1
- Now use the „
digit sub-address for your system.
Example: 1112 (address group = 11, sub-address = 12)
- After the fourth digit is entered the programming mode is automatically exited. The control
light LED goes off.
c) Restoring Factory Settings
To reset the remote control to its factory settings, first press and hold the "
at the same time ( for at least 5 seconds) until the control LED is lit.
Now release these buttons and press any button. As soon as the LED goes out, the remote
control is reset to its factory settings.
36
2 3 4
", „ ", „ " and „ " buttons to enter a 2-digit address group and a 2-
2 4
" and " " buttons