Setting A Single Address (Address Group/Sub-Address); Allocation Of Function Groups And Master Addresses - Conrad FS20 S20-3 Bedienungsanleitung

If several transmitters are to be operated in parallel and are intended to control different
receivers then the transmitter must be set to different addresses.
The factory setting for the remote control button pairs (see Chapter 8) is as follows for address
pairs (address group/sub-address):
Button pair:
Address:
Button pair:
Address:

For addressing when the double channel number is used: see below at the item
"Addressing with Double Channel Number".

1. Setting a Single Address (Address Group/Sub-Address)

To set the address group/sub-address, proceed as follows:
- Press both buttons of the respective button pair for simultaneously for at least 5 seconds
(e.g. for channel 1 press the buttons "
The control light LED starts flashing at one second intervals.
1
- Now use the „
digit sub-address for your system.
Example: 1431 (address group 14, sub-address 31)
- After the fourth digit is entered the programming mode is automatically exited. The control
light LED goes off.

Please note:
Both the address group 44 and the sub-address 44 are of special importance
(see the following item)!

2. Allocation of Function Groups and Master Addresses

Function groups (44xx)
If the address group is entered as 44, the sub-address will be defined as a function group
(so long as it is not 44 as well, see the following section). This allows 15 different function
groups to be defined between 4411 and 4443.

Possible settings: 4411, 4412, 4413, 4414, 4421, 4422, 4423, 4424, 4431,
4432, 4433, 4434, 4441, 4442, 4443
1 2
11 11 11 12
6 7
11 22 11 23
2 3 4
", „ ", „ " and „
3 4
11 13 11 14
8 9
11 24 44 11
1 2
" and " ").
" buttons to enter a 2-digit address group and a 2-
5
11 21
10
11 44
35