F) Copying Function For Device Settings; Light Scenes; Manual Setting - Renkforce Show Design 2 Bedienungsanleitung

• Push the REC/ENTER button (4) to save the settings for the respective effect light. All LEDs will flash
briefly to display successful storage.
• Repeat the process described as required to configure the FADE function for more effect lights.
• After you have made all changes, push the MENUS/ESC (5) button for approx. two seconds to leave the
menu.

f) Copying Function for Device Settings

The device settings can be copied from one effect light to another. This can save lots of setting work for
devices with the same channel assignment.
• Push the MENUS/ESC (5) button for approx. two seconds to get to the menu.
• The display (12) shows the first menu item „01. Patch fixture" (if this is not the case, select the item with
the dial switch PAN (11)).
• Push the REC/ENTER (4) button; the display (12) shows PLEASE SELECT FIXTURE.
• Push the selection button 1-16 (9) of the effect light for which you want to copy the channel assignment
and keep it pushed.
• Now push the selection button 1-16 (9) of the effect light to which you want to copy the settings. The
display will briefly show COPY and the two selected effect lights.
• Push the MENUS/ESC (5) button for approx. two seconds to leave the menu again.

12. Light Scenes

A light scene contains the DMX values of all DMX control channels of the connected effect lights.
a) Manual Setting
• Push the function button FIXTURE (2).
• Push the selection buttons 1-16 (9) of the effect lights that are involved in the light scene. The correspon-
ding LEDs must be lit.
To select the effect lights 1-16, level A must be selected with the PAGE (10) button. For effect
lights 17-32, level B must be selected with the PAGE (10) button.
To unselect a selected effect light again, push the corresponding button again (the
corresponding LED goes out).
To select and unselect several effect lights in sequence, keep the button of the first effect light
pushed and then push the button of the last effect light.
• Use the channel faders (1) and the dial switches PAN (11) and TILT (13) to set the desired light scene.
Once you use a channel fader or dial switch, the display (12) will show the number of the control
channel and the set DMX value.
46