Safety Information; Safety Notes - Renkforce Show Design 2 Bedienungsanleitung

5. Safety Information

The guarantee/warranty will expire if damage is incurred resulting from non-compliance with
these operating instructions. We do not assume liability for any consequential damage.
Nor do we assume any liability for damage to property or personal injury caused by improper
use or failure to observe the safety information. In such cases the warranty/guarantee is vo-
ided.
Dear Customer: The following safety information is intended not only for the protection of the
device but also for the protection of your health. Please read the following items carefully:
• To ensure that the device is set up correctly, always read these operating instructions inclu-
ding the safety instructions thoroughly and attentively before use.
• Check the device and mains unit for damage before using it. If the device is damaged, do not
operate it and consult an expert or our service team.
• For safety reasons, any unauthorized conversions and/or modifications to the product are not
permitted.
• The voltage source for the mains unit must be a proper mains socket (100-240 V / 50/60 Hz) of
the public mains grid. The DMX controller itself must only be supplied with energy through the
enclosed power mains unit.
• The DMX controller is still connected with the mains when it is switched off. To disconnect it
completely from the mains, the mains plug has to be pulled out of the socket.
• If the mains unit or its connection cable is damaged, do not touch it. First, power down the re-
spective mains socket (e.g. via the respective circuit breaker and FI switch) and then carefully
pull the mains unit from the mains socket.
• Never replace a damaged connection cable of the mains unit. If the connection cable is dama-
ged, the mains unit is unusable and must be disposed of. It must not be repaired.
• Never touch the power unit with wet or damp hands. There is a risk of potentially fatal electric
shock!
• All persons who operate this product, install it, assemble it, put it into operation or service it
must be trained and qualified accordingly and must observe these operating instructions.
• Devices that are operated with mains voltage have no place in the hands of children. There-
fore, be particularly careful when operating the device in the presence of children, in particular
keep them from trying to push objects into a device through the housing opening. There is the
risk of a potentially fatal electric shock.
• Never place containers containing liquids, e.g. glasses, buckets, vases or plants, on the device
or in its vicinity. Liquids may get into the housing and impair electrical safety. This also poses
great danger of fire or potentially fatal electric shock! If this is the case, first power down the
respective mains socket (e.g. switch off circuit breaker and FI switch) and then pull the mains
unit from the socket. Do not operate the product anymore afterwards, but take it to a specialist
workshop.
• Do not expose the device to any high temperatures, dripping or splashing water, strong vibra-
tions or heavy mechanical stress.
• Do not place any open sources of fire, such as burning candles, on or directly next to the de-
vice.
35