D) Inversion Of The Control Channels; E) Fade Function For The Effect Lights - Renkforce Show Design 2 Bedienungsanleitung

d) Inversion of the Control Channels

With this function, you can reverse the fader path of the channel fader (1) and the dial switches PAN (11)
and TILT (13).
• Push the MENUS/ESC (5) button for approx. two seconds to get to the menu.
• The display (12) shows the first menu item „01. Patch fixture" (if this is not the case, select the item with
the dial switch PAN (11)).
• Push the REC/ENTER (4) button; the display (12) shows PLEASE SELECT FIXTURE.
• Push the selection button 1-16 (9) of the effect light to be edited.
To select the effect lights 1-16, level A must be selected with the PAGE (10) button. For effect
lights 17-32, level B must be selected with the PAGE (10) button.
• Use the RUN MODE/SWAP (7) button to select the menu item FADER REVERSE.
• The display (12) shows the selected control channel of the DMX controller on top (e.g. 1/R) and
REVERSE YES/NO at the bottom.
• Use the dial switch PAN (11) to set the control channel of the DMX controller and the dial switch TILT (13)
to select YES or NO.
YES = Control channel is inverted.
NO = Control channel is not inverted.
• Push the REC/ENTER button (4) to save the settings for the respective control channel. All LEDs will flash
briefly to display successful storage.
• Repeat the process described as required to invert further control channels.
• After you have made all changes, push the MENUS/ESC (5) button for approx. two seconds to leave the
menu.

e) FADE Function for the Effect Lights

With this function, a fade-in effect for brightness of the individual colours (R, G, B, W) and the overall bright-
ness can be configured in the effect lights.
• Push the MENUS/ESC (5) button for approx. two seconds to get to the menu.
• The display (12) shows the first menu item „01. Patch fixture" (if this is not the case, select the item with
the dial switch PAN (11)).
• Push the REC/ENTER (4) button; the display (12) shows PLEASE SELECT FIXTURE.
• Push the selection button 1-16 (9) of the effect light to be edited.
To select the effect lights 1-16, level A must be selected with the PAGE (10) button. For effect
lights 17-32, level B must be selected with the PAGE (10) button.
• Use the RUN MODE/SWAP (7) button to select the menu item COLOR FADE.
• The display (12) shows the selected effect light (e.g. FIXTURE 01) on the left and [YES] or [NO] at the
right.
• Use the dial switch PAN (11) to select [YES] or [NO].
[YES] = Fade-in effect on
[NO] = Fade-in effect off
45