Renkforce Show Design 2 Bedienungsanleitung Seite 55

• Push the RUN MODE/SWAP (7) button to indicate the UID (manufacturer ID and serial number) or the
RDM device in the upper display line.
• Push the BLACK OUT/DEL button (6) to perform the Identify function of the device.
• Push the MENUS/ESC (5) button to return to the main level of the menu afterwards.
06. Data backup
This function backs up the saved DMX settings, light scenes and running light functions on a USB drive.
There are 16 memory slots available for this.
USB storage media with the file system FAT32 and a max. capacity of 32 GB are supported.
If the storage medium is not recognised by the DMX controller, switch it off and on again.
• Connect your USB drive to the USB port (3).
• Turn the dial switch PAN (11) until the above menu item appears in the display (12).
• Push the REC/ENTER (4) button.
• DATA BACKUP USB will appear in the display (12).
• Use the dial switch PAN (11) to select [YES] and push the REC/ENTER (4) button again.
• PRESS NUMBER KEY SELECT FILE appears in the display (12).
• Use the selection buttons 1-16 (9) to select the memory slot you want to start data backup. The
display (12) shows FILE:x (x = memory slot number) with a progress display.
Data backup must be performed separately for each memory slot. When the LED of a memory slot
is lit, this means that this memory slot has already been saved on the USB drive.
• When data backup has been successfully completed, the display (12) will switch back to the main level.
A folder with the name „show-design2" is set up on the USB drive. Every backed-up memory slot
is stored in the file „File" (consecutive number) with the extension PRO.
Do not make any manual changes to the backed-up data, since it would no longer be possible to
read in the data then.
55