Safety Instructions - Conrad 75 02 68 Bedienungsanleitung

The camera may used in dry interior spaces only.
Please keep in mind that you will render yourself liable to prosecu-
tion, if you keep persons under observation without their knowledge
and approval with this camera.
This product has been approved for connection to 12 Volt constant
voltage only.
Uses other than those described above are not permitted. They will
lead to damage to the product and may cause additional risks,
such as short circuit, fire, electric shock et cetera.
The entire product may not be changed or modified in any way.
The safety instructions have to be observed without fail !

Safety instructions

Damage due to non-compliance with these operat-
ing instructions leads to expiry of the warranty. We
do not accept liability for consequential damage!
We do not accept liability for damage to property or
personal injury caused by improper handling or non-
compliance with the safety instructions. Under
these circumstances, any warranty expires.
For safety and certification (CE) reasons, unauthorised modifica-
tions and/or changes to the camera are not permitted.
Consult suitably qualified staff, if you have doubts about how the
equipment operates or about how to connect it safely.
Comply with the safety and operating instructions of any other
appliances that are connected to the device as well as to the indi-
vidual chapters in these instructions.
Do not leave the packaging material lying around carelessly. Plastic
films and/or bags and polystyrene parts et cetera may become dan-
gerous toys in the hands of children.
14
If safe operation can no longer be assumed, the camera and/or the
power supply unit have to be put out of service and precautions
have to be taken to avoid unintentional use. Disconnect the power
plug from the mains socket!
Reasons to assume that safe operation is no longer possible
include:
• the camera or the connecting cables of power supply units are
visibly damaged
• the camera or the connected power supply units no longer oper-
ate
• after storage for long periods under unfavourable conditions
• after considerable stress during transport
In the event of a fault, power supply units may release more than 50
VDC, which may be dangerous, even if the initial voltage of the pow-
er supply unit is lower.
It is imperative that these safety instructions be followed before
the camera or a connected device is cleaned or maintained.
Live components may be exposed when covers are
opened or components are removed.
Before cleaning or servicing, the device has to be dis-
connected from all voltage sources.
Capacitors in the device may still be charged, even if it
has been disconnected from all voltage sources.
Never replace any damaged connecting cable of power
supply unit yourself. In such a case disconnect the units
from the mains voltage and take them to a specialist
workshop
Repair work always has to be carried out by qualified
experts familiar with the hazards involved and with the
relevant regulations.
19