Safety Instructions; Battery Installation; Weather Station - Conrad Electronic WS-9611IT Bedienungsanleitung

4. Safety instructions

We do not assume liability for resulting damages to property or personal
injury if the product has been abused in any way or damaged by improper
use or failure to observe these operating instructions. The warranty will then
expire!
An exclamation mark in a triangle indicates important information in the
operating instructions. Carefully read the whole operating instructions before
operating the device, otherwise there is risk of danger.
• Unauthorised conversion and/or modification of the device are inadmissible because of safety
and approval reasons (CE).
• This product must not be operated in hospitals or medical institutions. Although the outdoor
sensor emits only relatively weak radio signals, these may lead to malfunction of life-supporting
systems. The same may be the case in other areas.
• The product should be handled with care. Do not drop it, as it may be damaged by the impact.
• The product must not be subjected to heavy mechanical stress.
• The product must not be exposed to extreme temperatures, direct sunlight or intense
vibration.
• The product is not a toy and should be kept out of reach of children!
• Do not leave used packing material unattended, as they may be dangerous for children playing
with them.
• Do not expose the product to extreme and sudden fluctuations in temperature, since this leads
to rapid change of display information and thus to impairment of the precision of the data.
• The manufacturer or supplier assumes no responsibility for the display of incorrect data or the
consequences that an incorrect display could have.
• If there is reason to believe that safe operation is no longer possible, the device is to be put out
of operation and secured against unintended operation. Safe operation is no longer possible
if the device:
- shows visible damages,
- no longer works,
- was stored under unfavourable conditions for a long period of time or
- was subject to considerable transport stress.
• Servicing, adjustment or repair works must only be carried out by a specialist/ specialist
workshop.
• If any questions arise that are not answered in this operating instruction, please contact our
Technical Advisory Service or other experts.
34

5. Battery installation

Observe correct polarity while inserting the battery. Remove the battery if the
device is not used for a long period of time to avoid damage through leaking.
Leaking or damaged battery might cause acid burns when contact with skin,
therefore use suitable protective gloves to handle corrupted battery.
Keep battery out of reach of children. Do not leave the battery lying around, as
there is risk, which children or domestic pets could swallow it.
Make sure that battery is not dismantled, short-circuited or thrown into fire.
Never recharge non-rechargeable battery. There is a risk of explosion!
A) Weather station
1. Remove the battery case cover on the back of the weather station.
. Insert the batteries while paying attention to the correct polarity ("+" positive; "-" negative)
(two 1.5 V batteries, type AA Mignon).
3. Put the cover back on.
B) Outside temperature transmitter
1. Remove the battery case cover from the back of the outside transmitter.
. Insert the batteries into the battery case while paying attention to the correct polarity
"+" positive; "-" negative) (two 1.5 V batteries, type AA Mignon).
3. Put the cover back on.
In case of a change of batteries in one of the units, a new basic setting must be
undertaken with all units. This is necessary since upon being put into operation,
the outside transmitter transmits a random security code to the weather station
which must be received and stored within the first 3 minutes after being put into
operation.
35