Werbung
If pressure remains in the housing, it is almost impossible to open the
filter housing cap. Pull out used filter cartridge and replaced it by a new
one. Make sure O-ring is in place and in useable condition. Fit spring on
top of filter. Screw cap on hand tight. Check filter housing for air leaks
during the next filling process.
Conservation of compressor
If the compressor will not be used for a long period of time the following
steps
should be taken:
Run the compressor for about 10 minutes
Open filling hose valve and let the compressor run for another five
minutes
Turn the compressor off
Release all pressure and condensate
Close the filling hose valve
Fill up fuel tank to top level to avoid corrosion (LW 190 B)
The compressor should be stored in a dry and dust free place
Before restarting the compressor, the following steps should be
carried out:
Change oil (if the compressor was out of use for more than 12 months)
Check air intake filter
Replace mole carbon filter cartridge
Check oil level(s)
Check fuel level (LW 190 B)
Check condition of filling hose
Start compressor
Run the compressor with open filling valves for 5 minutes
Close filling valve
Drive compressor close to 200 bar and control connections for air leaks
Release pressure and drain water separators
The compressor is now ready for use.
8
Werbung
