Inhaltsverzeichnis; Operating Elements; Safety Information - Conrad 61 90 19 Bedienungsanleitung

1
2

Operating elements

1 Power plug with earth contact
2 Power socket with earth contact
3 Three-colour "Status" LED
4 "MANUAL" button for operation by hand
5 "LEVEL" button for brightness setting (dimming)
6 Infrared sensor
Contents
Introduction ......................................................................................2
Intended use.....................................................................................3
Operating elements ..........................................................................4
Contents ...........................................................................................4
Safety information ............................................................................5
Connection, putting into operation...................................................6
Disposal ............................................................................................8
Fault rectification ..............................................................................8
Maintenance .....................................................................................9
Technical data.................................................................................10
4
3
6
4 5

Safety information

• The instrument left the factory in perfect technically-safe conditi-
on. To maintain this condition and to ensure safe operation, it is
essential for the user to observe the "Intended use" and "Safety
information" chapters and warning notes (Attention!) contained in
these user instructions.
• The unit is earthed throughout and may therefore only be
connected to and operated with an earthed 230 V AC supply and
an earthed mains plug/socket adapter as required in certain
countries.
• Care must be taken to ensure that the (yellow/green) earth wire
remains in good condition in the unit and in the AC supply, be-
cause a damaged earth wire can endanger life. Care must also
be taken to ensure that insulation is neither damaged nor dest-
royed.
• The IR Power Switch with Dimmer is not a toy and so does not
belong in the hands of children!
• In commercial facilities the accident-prevention regulations of
the Industrial Employers' Liability Association for electrical sy-
stems and equipment must be observed.
• In schools, training facilities, hobby and self-help workshops, the
Page
handling of electrical equipment must be supervised responsibly
by trained personnel.
• Before putting into operation on each occasion, check the IR Po-
wer Switch with Dimmer for damage.
• Do not use the IR Power Switch with Dimmer in areas or under
adverse environmental conditions, when combustible gases, fu-
mes or dust are present or can occur.
• The case of the IR Power Switch with Dimmer must not come in-
to contact with hot objects (hotplates, soldering irons, hot air
equipment, etc.).
5