Problem Cart; Replacing The Crossfader - Omnitronic FX-524 Kill-Mixer Bedienungsanleitung

6. PROBLEM CART

PROBLEM:
No power. • The power-cord is not connected.
No sound. • The PHONO/LINE/MIC-switch of the
respective channel is in the wrong position.
• The power-cord of the respective device is
not connected properly or not connected at
all.
• The connection-socket or the plug is dirty.
Noise. • The input-signal is too strong.
No crossfader. • The crossfader was not assigned properly.

7. REPLACING THE CROSSFADER

Instructions for replacing the crossfader:
• Remove the fader knob.
• Remove the two outer screws on the fader-panel.
• Take the fader out and unplug the connection-cable.
• Connect the new fader and fix it in the device.
The fader-panel of the replacement-crossfader cannot be used for the Design-version. In order to exchange
the fader-panels, additionally unscrew the 2 inner screws and exchange the two fader-panels.
CAUSE:
23
REMEDY:
• Check the power-cord and any extension-
cables.
• Put the PHONO/LINE/MIC-switch into the
correct position.
• Check the power-cord and if the plugs are
tightly connected with the sockets.
• Clean the socket and/or the plug.
• Reduce the inputs-signal via the Gain-
control.
• Assign the desired channel to the cross-
fader via the Crossfader Assign-button.