Problem Chart; Replacing The Crossfader - Omnitronic PM-3010 Bedienungsanleitung

12. ZONE
You can either connect monitor active speakers for the DJ-Booth or an additional amplifier for creating
another zone.
13. OUTPUT LEVEL-SELECTOR
Used to switch the output level to 0.75V or 1.5V.
14. AC CONNECTION
Plug the power supply cable in here.

PROBLEM CHART

PROBLEM:
No power.
No DJ.
Noise.
While you are changing the
crossfader assignment, the
master-output cuts off.
The desired channels
cannot be synchronized.

REPLACING THE CROSSFADER

Instructions for replacing the crossfader:
• Remove the fader knob.
• Remove the two outer screws on the fader-panel.
• Take the fader out and unplug the connection-cable.
• Connect the new fader and fix it in the device.
CAUSE:
• The power unit is not connected.
• The INPUT SELECT-switch of the
respective channel is in the wrong
position.
• The power-cord of the respective
device is not connected properly or
not connected at all.
• The connection-socket or the plug is
dirty.
• The input-signal is too strong.
The assignment of both Assign button
overlaps.
The wrong channels have been
selected with the Assign selector.
24/26
REMEDY:
• Check the connection cable of the
power unit and any extension-cables.
• Put the INPUT SELECT-switch into
the correct position.
• Check the power-cord and if the
plugs are tightly connected with the
sockets.
• Clean the socket and/or the plug.
• Reduce the input-signal via the Gain-
control.
Switch the crossfader off with one of
the Assign-button before you change
the assignment.
Select the correct channels.
10006850_V_1_0