Rearpanel - Omnitronic FX-524 Kill-Mixer Bedienungsanleitung

5.2 Rearpanel

(25) GND (Ground terminal)
Connect the ground lead of the turntable with this terminal. This helps to reduce humming and pop noises.
(26) MIC 2-SOCKET
Connect your microphone with ¼" jack plug here. The signals can be controlled via CH-2, if the PHONO 2 /
LINE 2 / MIC 2-switch is set to MIC 2.
(27) MIC 3-SOCKET
Connect your microphone with ¼" jack plug here. The signals can be controlled via CH-3, if the PHONO 3 /
LINE 3 / MIC 3-switch is set to MIC 3.
(28), (29), (30) LINE / PHONO INPUT-SOCKETS
Input socket for CH-1, CH-2 and CH-3. Connect your turntable(s) with the PHONO input-sockets. CD-players
or Tape Decks should be connected with the LINE input-sockets. Line level musical instruments with stereo
outputs such as Rhythm Machines or Samplers should also be connected with the LINE input-sockets.
(31) REC OUT
To connect your recording unit. The REC OUT-level is not influenced by the Master-control.
(32) BOOTH
Connect your monitor system here.
(33) MASTER OUT
Output sockets for connecting your power amplifier.
(34) FUSEHOLDER
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same rating and
power.
(35) AC-CONNECTION
Used to plug the power-cord in.
(36) AC VOLTAGE-SELECTOR
Make sure that the selector is properly set.
22