7. REPLACING THE CROSSFADER
Instructions for replacing the crossfader:
• Remove the fader knob.
• Remove the two outer screws on the fader-panel.
• Take the fader out and unplug the connection-cable.
• Connect the new fader and fix it in the device.
The fader-panel of the replacement-crossfader cannot be used for the Design-version. In order to exchange
the fader-panels, additionally unscrew the 2 inner screws and exchange the two fader-panels.
8. TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
Inputs:
Minimum input voltage:
Microphone:
Phono:
Line:
Output power:
Line:
Headphones:
Headphones impedance:
Outputs:
Master 1 Out:
Frequency range:
Microphone:
Phono:
Line:
Distortion:
S/N-ratio:
Microphone:
Phono:
Line:
Talkover-attenuation:
Tone control:
Treble:
Middle:
Bass:
Dimensions:
Weight:
Replacement crossfader:
Please note: errors and omissions for every information given in this manual excepted. Every
information is subject to change without prior notice. Any claim due to missing or wrong information
in this manual is herewith excluded! 2/99 ©
230 V/50 Hz
115 V/60 Hz
18 W
3 phono, 4 line, 3 aux, 2 mic
3 mV RMS, 10 kOhms
1.2 mV RMS, 47 kOhms
78 mV RMS, 10 kOhms
9 V RMS max.
0.5 V
47 Ohms
2 Master-Out, 1 Rec-Out, 1 Booth-Out via RCA
via 2 additional, balanced XLR-connectors
40 - 15,000 Hz, ± 0.5 dB
20 - 20,000 Hz, ± 1 dB
20 - 20,000 Hz, ± 0.5 dB
< 0.01 %
> 80 dB
> 78 dB
> 88 dB
-15 dB
20 Khz -30 dB to +15 dB
1.2 KHz -30 dB to +15 dB
40 Hz -30 dB to +15 dB
482 x 242 x 108 mm
19"-dimensions with 5 u
4.8 kg
No. 10007190
22