Update Process - SELFSAT SNIPE DOME Bedienungsanleitung

4-2. Update Process

Using SNIPE DOME Update Program, refresh the satellite date of your SNIPE DOME.
i. Please connect the main unit – controller – PC
ii. Download the update program on our website (http://www.selfsat.com) as the following
instruction.
01. Click [S/W update] of the model you want to update and download the update program.
02. Download the satellite information.
(Make sure you check the product model and the region, and download the correct satellite
information)
03. Download the USB Serial Driver File.
iii. Install [USB Serial Drive]
iv. Installation
2
12
1
5
01. Connect the USB cable and turn on the
controller. Please check [USB Serial Converter]
port has been activated on [PC and devices].
02. When everything is connected properly and the
controller is turned on, but if [USB Serial
Converter] is still not activated, please download
the USB Driver attached on the home page.
01. Please download the SNIPE DOME update
program.
- Unzip [update program].
- Open [setup.exe] and do as the following
pictures.
5
4