SELFSAT SNIPE DOME Bedienungsanleitung Seite 14

v. Proceeding Update
NOTE
If you see [Invalid port] message after clicking [scan ports], please check if
you selected the correct port, and if you see [Invalid port] message even if
you chose the correct one, please change the setting as below; you do not
need to follow until 5-3 if you do not see [Invalid port] message.
02-a. Click the com port on the [Device manager] and
click properties.
02-c. Go to [Advanced...]
01.
02.
02-b.
a
02-d.
c
Open the installed update program and you will
see the screen.
Turn on the controller and click [Scan Ports].
The Port name might be different depending on
the PC models.
Go to [Port Settings]
b
Change the COM Port Number to one of the low
numbers and select [OK].
d
13