SELFSAT SNIPE DOME Bedienungsanleitung Seite 16

08. If you would like to update other satellites too, please check the satellite you want and do the same.
NOTE
You can also proceed the update manually, by changing the values
arbitrarily on the screen.
If you put incorrect data, ERROR message will be shown.
- Please read the ERROR message and correct the information as the
instruction.
- If you had put correct information and if [Data Format ERROR] is keep
shown, please put different data or contact service@selfsat.com.
vi. Lastly, operate the SNIPE DOME and see if it searches the updated satellite properly.
If SNIPE DOME still cannot search the satellite even after the update was completed, please try
updating again, or contact service@selfsat.com.
NOTE
Do not turn off the power or disconnect the cable before update procedure
is completed.
How to update satellite information can be changed by reflecting the
newest satellite information.
Please make sure to get how to update the product through our web site
(www.selfsat.com)
07. Check [Update has been completed].
NOTE
In case the controller power was
turned off or cable was discon-
nected or any of such things
happened to stop the process
while updating, please proceed the
update process from the first again.
15