Storage; Waste Disposal And Environ- Mental Protection; Replacement Parts/Accessories - FLORABEST FSG 85 B1 Betriebsanleitung

GB IE CY
5. Put the grinding disk cover (3)
back on.
Do not tighten the grinding disk nut
too much because this may cause
the grinding disk and nut to break.
6. Test run: Before starting work and af-
ter each change of grinding disk, carry
out a test run of at least 30 seconds
with no load. Switch off the equipment
immediately if the disk runs lumpy, sub-
stantial vibrations occur or abnormal
noises are generated.

Storage

• Store the appliance in a dry place well
out of reach of children.
Grinding disks must be stored dry
and upright and are not to be
stacked.

Replacement parts/accessories

Spare parts and accessories can be obtained at www.grizzly-service.eu
If you do not have internet access, please contact the Service Centre via telephone
(see "Service-Center" page 16). Please have the order number mentioned below ready.
Position Position
Instruction Exploded
manual drawing
3 Set 3
4 Set 4
12 Set 1
18a 33
18b/18c Set 2
14
Waste disposal and en-
vironmental protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Hand over the device at an utilization loca-
tion. The plastic and metal parts employed
can be separated out into pure materials
and recycling can be implemented. Ask
your Service Center about this. Defective
units returned to us will be disposed of for
free.
Description
Grinding disk cover
Handle with screw
Chain clamping unit and rotary disk
Grinding disk
Grinding disk nut and hub
Machines are not to be place with
domestic waste.
Order
number
91102832
91102833
91102830
30211030
91102831