Original Ancillaries / And Accessories; Operation; Switching On And Off; Setting The Oscillation Speed - Parkside PSS 250 Bedienungs- Und Sicherheitshinweise

General safety advice for electrical power tools / Operation
a stop before setting down the oscil-
lating sander.
J
Always pull the power plug out of the
socket for all work pauses, before any
work on the appliance (e.g. changing
the sanding paper) and when not in use.
J
the appliance must always be kept
clean, dry and free of oil or lubricat-
ing greases.
original ancillaries / and
Q
accessories
J
Only use accessories and tools that are specified
in the operating instructions. The use of tools
and accessories other than those recommended
in the operating instructions could lead to an
increased risk of personal injury for you.

operation

Q
operation
Q
Take note of the mains voltage! The voltage must
agree with the information on the type plate of
the appliance (appliances that are designated as
230 V can also be connected to 220 V).

Switching on and off

Q
Switching on intermittent function:
j
Press the ON / OFF switch
Switching off intermittent function:
j
Release the ON / OFF switch
Switching on continuous operation :
j
Press the ON / OFF switch
and press the locking button
Switching off continuous operation:
j
Press the ON / OFF switch
again.
20 GB
Q
You can set the desired oscillation speed as
needed with the oscillation speed selector
The required oscillation speed depends on the
material being worked and can be determined
through practical tests.
Q
appliance, always disconnect the power.
notE: Before attaching a new sanding pad
remove dust and dirt from the sanding plate
Sanding sheets with hook and loop
fastening:
j
j
Sanding sheets without hook and loop
fastening:
j
j
j
Various materials require different grit values. You
can read which grit value is best suited for which
work in our recommendations under "Instructions, tips
1
.
and tricks".
1
.
Q
, hold it pressed
1
2
.
collection box
then release it cleaner via an external suction adapter! Under cer­
1
tain conditions the sanding dust in the dust box (or
in the vacuum's dust bag) may self­ignite, e.g. as
a result of flying sparks generated when abrading

Setting the oscillation speed

Attaching a sanding pad

WArnInG!
Before performing work on the
Fix one side of the sanding sheet
one side of the backing plate
Then attach the sanding sheet
ing plate and press it firmly into place.
8
Open the two clamping levers
Push one end of the sanding sheet
the open clamping bar
sheet firmly in place by locking the clamping
lever back in place.
7
Repeat this procedure at the other end.

Vacuuming dust

WArnInG!
A risk of fire exists when working with
electrical appliances that have a dust
or can be attached to a vacuum
4
.
10
,
9
.
8
flush with
9
.
8
to the back­
9
.
7
under
9
and clamp the
6
FIrE HAzArD!