Original Ancillaries / And Accessories; Operation; Switching On And Off; Setting The Oscillation Speed - Parkside PSS 250 A1 Bedienungs- Und Sicherheitshinweise

on materials that give rise to dusts that are haz-
ardous to health, the sander must be connected
to a suitable external dust extraction device.
Wear protective glasses and a dust
mask!
Ensure sufficient ventilation when
working on plastics, paints, lacquers,
etc.
Do not soak materials or surfaces to be
worked with liquids containing solvents.
Avoid sanding of lead-based paints or
other materials that are hazardous to
health.
Material containing asbestos may not
be worked on. Asbestos is considered a
carcinogen.
The appliance is designed for dry sur-
face sanding of wood, plastic, metal
and smoothing compounds as well as
painted surfaces.
Never work on moistened materials
or wet surfaces. Water entering an electri-
cal device increases the risk of electric shock.
Always hold the appliance firmly with
two hands while working (see also
Fig. D, E).
Never support your hands next to or
in front of the device or on the surface
being worked as there is a risk of in-
jury in the event of slipping.
Always switch off the appliance and
allow the sanding sheet
a stop before setting down the oscil-
lating sander.
Always pull the power plug out of the
socket for all work pauses, before any
work on the appliance (e.g. changing
the sanding paper) and when not in use.
The appliance must always be kept
clean, dry and free of oil or lubricat-
ing greases.
Original ancillaries / and
accessories
Only use accessories and tools that are
specified in the operating instructions.
General power tool safety warnings / Operation
Switching on intermittent function:
Switching off intermittent function:
Switching on continuous operation:
Switching off continuous operation:
You can set the desired oscillation speed as needed
with the oscillation speed selector
The required oscillation speed depends on the ma-
terial being worked and can be determined through
to come to practical tests.
9
appliance, always disconnect the power.
NOTE: Before attaching a new sanding sheet
remove dust and dirt from the sanding plate
Sanding sheets with hook and loop
fastening:
The use of tools and accessories other than
those recommended in the operating instructions
could lead to an increased risk of personal in-
jury for you.

Operation

Switching On and Off

Press the ON / OFF switch
Release the ON / OFF switch
Press the ON / OFF switch
and press the locking button
Press the ON / OFF switch
again.

Setting the oscillation speed

Attaching a sanding sheet

Before performing work on the
Fix one side of the sanding sheet
one side of the backing plate
Then attach the sanding sheet
ing plate and press it firmly into place.
8
.
1
.
1
, hold it pressed
1
.
2
then release it
1
.
10
,
9
.
8
flush with
9
.
8
to the back-
9
GB/IE 9